Directions
for use:
· QuickStrip
is used full strength with mineral oil seal, heated to 160-180 F.
· Most coatings are completely removed in 1 – 4 hours
soak time. Polyamides generally require 3-4 hours soaktime.
Epoxies and polyurethane’s are stripped within 30 minutes.
Landing gear parts, brake assemblies, aircraft wheels, etc., depends
on the type of coating, age and thickness. QuickStrip
can also be used to strip aluminum and silicone coatings as well
as baked on phenolics and carbon from heat exchangers.
· After soaking, remove and rinse parts with water away from
the tank to prevent contamination of the stripper. WARNING:
Do not allow water to enter the tank, as this will adversely affect
the performance of the product.
· Testing of the QuickStrip in the tank
should be done every 30 – 60 days to evaluate and adjust product
components levels in the tank. Testing of the stripping tank
ensures product performance and extends the life of the QuickStrip
product.
· Contact AeroChem for instructions on tank filtration and
information on Additive A and B. |
| 
IMPORTANT: Before using this
product, always be sure to read and follow warnings and directions
for uses appearing on the product container label, MSDS, and applicable
current technical manual. |
